Hi Kevin=2C
I think you meant SI-912-10. But it doesn't tell me what to do in my case.
I did drain the oil from the hose coming out of the bottom of the engine=2C
but have always done that before. I'll keep handcranking.
Karl
From: kevann@gotsky.com
Subject: Re: Europa-List: Oil change question
Date: Wed=2C 17 Nov 2010 17:46:42 -0800
Karl=2C
Follow the Rotax Service Instructions
SI-912-020=2C SI-914-021 I get them at www.rotaxowner.com
If you introduced air into the system and do not then
properly purge the system=2C severe engine damage could result.
Kevin
----- Original Message -----
From:
Karl Heindl
To: europa-list@matronics.com
Sent: Wednesday=2C November 17=2C 2010 4:39
PM
Subject: Europa-List: Oil change
question
I don't usually have a problem with getting the oil
pressure back after an oil change=2C but this time I seem to have an airl
ock.
I was going to bypass the tank and connect the in/out hoses together and
crank the engine for a few seconds (I am not using ignition).
Is that okay ?
Thanks for any input.
Karl
href="http://www.aeroelectric.com";>www.aeroelectric.com
href="http://www.buildersbooks.com";>www.buildersbooks.com
href="http://www.homebuilthelp.com";>www.homebuilthelp.com
href="http://www.matronics.com/contribution";>http://www.matronics.com/chr
ef="http://www.matronics.com/Navigator?Europa-List";>http://www.matronhref
="http://forums.matronics.com";>http://forums.matronics.com
|