before I cut the back edge of the XS cowl for a 912S I'd like to check that its
normal to take about 2mm off the port side and 12 mm off the starboard. I
realise
the engine is 1.5 off to starboard but I dont know if the cowl design caters
for this already. My engine didnt need any adjustment washers and I measured
the angle at 1.57 deg.
Thanks
--------
Graeme Bird
G-UMPY
Mono Classic/XS FWFD 912ULS/Warp drive FP
Build nearing completion
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=332929#332929
|