I am finally getting close to the end.=C2- Today I took out the rubber do
or seal and started to look at putting it on.=C2- There is a diagram in t
he manual that shows how it fits, and it makes sense.=C2- The rubber has
a small channel that should fit the=C2-edge of the rebate.=C2- Where th
ere is only a single ply, this works fine.=C2- Where the door frame is tw
o plies thick, the rubber=C2- is not flexible enough to get on.=C2- In
this case, it would seem that=C2-the edge should be cut down to a thickne
ss that the rubber will go over.=C2- A Perma-Grit or die grinder would do
it.=C2- Do I understand this=C2-correctly?=C2- Also, they do not men
tion how to fasten the rubber in; it would seem to me that a little=C2-FL
OX would be appropriate.=C2- Is this correct?
END IN SIGHT!
Jim Puglise - A283
Punta Gorda, FL=C2-=C2- =C2-
|