Jim,
As others have stated... A small rubber or plastic mallet and you're
good to go. Be sure to tap the seal deep into the corners...
Jeff - Baby Blue
On 3/9/2011 5:55 PM, jimpuglise@comcast.net wrote:
> I am finally getting close to the end. Today I took out the rubber door
> seal and started to look at putting it on. There is a diagram in the
> manual that shows how it fits, and it makes sense. The rubber has a
> small channel that should fit the edge of the rebate. Where there is
> only a single ply, this works fine. Where the door frame is two plies
> thick, the rubber is not flexible enough to get on. In this case, it
> would seem that the edge should be cut down to a thickness that the
> rubber will go over. A Perma-Grit or die grinder would do it. Do I
> understand this correctly? Also, they do not mention how to fasten the
> rubber in; it would seem to me that a little FLOX would be appropriate.
> Is this correct?
>
> END IN SIGHT!
>
> Jim Puglise - A283
>
> Punta Gorda, FL
>
> *
>
>
> *
|