Karl,
I added a 2nd banjo fitting to the output side of the fuel pressure regulator.
It required replacing the single banjo bolt with a double banjo bolt. See:
http://www.europaowners.org/forums/gallery2.php?g2_itemId=65989
---From my build album, year #6 Q1 2007 where I installed the fuel
pressure/airbox
pressure differential gage. This connection went to the fuel pressure side of
the sensor. You could use the same type of connection for a fuel pressure
sensor.
Blue skies & tailwinds,
Bob Borger
http://www.europaowners.org/N914XL
Europa XS, Short Wing, Intercooled Rotax 914
rlborger@mac.com
Cel: 817-992-1117
On Aug 2, 2011, at 8:09 PM, Karl Heindl wrote:
> I would also like to wire a fuel pressure sender to my EIS. But where would I
find the T-adapter that the VDO sender is screwed into. I assume that is the
way it is done, similar to the coolant temperature sender.
>
> Thank you for any help
>
> Karl
|