On 08/06/2011 11:59 AM, John Greenhalgh wrote:
> I have checked the ground and thats OK and then I checked the voltage
> of the power source at the connector to the sensor between the red and
> black wires and this was 10.6 volts which is a surprise
If I recall correctly this sensor needs 5 Volts. If that is the case it
is not surprising that it drags the supply down to 10.6Volts. You might
have damaged the flowscan, but check to be sure what the required
voltage is, I hope for you that my memory is wrong.
Frans
|