John=0Athere is also a regulated 5v supply from the EIS I forgot which pin
it is but I =0Acan find out iof you need it=0AGraham=0A=0A=0A=0A=0A________
________________________=0AFrom: Frans Veldman <frans@privatepilots.nl>=0AT
o: europa-list@matronics.com=0ASent: Saturday, 6 August, 2011 16:47:44=0ASu
bject: Re: Europa-List: FlowScan Problems=0A=0A--> Europa-List message post
ed by: Frans Veldman <frans@privatepilots.nl>=0A=0AOn 08/06/2011 11:59 AM,
John Greenhalgh wrote:=0A> I have checked the ground and thats OK and then
I checked the voltage=0A> of the power source at the connector to the senso
r between the red and=0A> black wires and this was 10.6 volts which is a su
rprise=0A=0AIf I recall correctly this sensor needs 5 Volts. If that is the
case it=0Ais not surprising that it drags the supply down to 10.6Volts. Yo
u might=0Ahave damaged the flowscan, but check to be sure what the required
=0Avoltage is, I hope for you that my memory is wrong.=0A=0AFrans=0A=0A=0A_
-========================
===============
|