Gents (and Ladies),
During this years maintenance, I'm considering putting a new fuel valve into my
flying Europa to replace the 6749 valve - which I suspect is weeping a bit
(responsible
for the cockpit fuel smell problem? Does anyone have any advice/experience
of using the Andair range of selectors fitted to the upper horizontal
surface of the tunnel - just aft of the instrument panel? Not sure in
particular
if at that height (about 350mm higher than the tank outlets) it may cause
problems - and if to overcome that, if anyone has used a remote selector
connected
by a shaft to the valve sited closer to the fuselage floor? Soonest replies
appreciated.
Clive Sutton
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=414835#414835
|