On 4 Dec 2013, at 13:21, gtagr wrote:
> Does anyone have any advice/experience of using the Andair range of selectors
fitted to the upper horizontal surface of the tunnel - just aft of the
instrument
panel? Not sure in particular if at that height (about 350mm higher than
the tank outlets) it may cause problems - and if to overcome that, if anyone
has used a remote selector connected by a shaft to the valve sited closer to the
fuselage floor?
Clive - I installed my Andair selector before I bonded in the cockpit module
(which
is probably a lot easier than doing it as an upgrade to an existing
installation).
You can see some of the pictures of my installation at;
http://www.rowlandcarson.org.uk/aviation/europa_435/fuel_valve_trial.php
and
http://www.rowlandcarson.org.uk/aviation/europa_435/fuel_pipes.php
and other pictures nearby in the sequence.
I haven't yet had official approval of this specific arrangement, but I believe
it is quite similar to what some others have done.
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
|