Hi Rowland - in your installation using metal fuel pipes instead of rubber
hoses,
where are your fuel filters - aren't they installed between the tank and the
fuel selector when you use rubber hoses or have I misunderstood the build
manual?
Richard CC
Sent from my iPad
> On 4 Dec 2013, at 15:21, Rowland Carson <rowlandcarson@gmail.com> wrote:
>
>
>
>> On 4 Dec 2013, at 13:21, gtagr wrote:
>>
>> Does anyone have any advice/experience of using the Andair range of selectors
fitted to the upper horizontal surface of the tunnel - just aft of the
instrument
panel? Not sure in particular if at that height (about 350mm higher than
the tank outlets) it may cause problems - and if to overcome that, if anyone
has used a remote selector connected by a shaft to the valve sited closer to
the fuselage floor?
>
> Clive - I installed my Andair selector before I bonded in the cockpit module
(which is probably a lot easier than doing it as an upgrade to an existing
installation).
>
> You can see some of the pictures of my installation at;
>
> http://www.rowlandcarson.org.uk/aviation/europa_435/fuel_valve_trial.php
>
> and
>
> http://www.rowlandcarson.org.uk/aviation/europa_435/fuel_pipes.php
>
> and other pictures nearby in the sequence.
>
> I haven't yet had official approval of this specific arrangement, but I
> believe
it is quite similar to what some others have done.
>
> in friendship
>
> Rowland
>
> | Rowland Carson ... that's Rowland with a 'w' ...
> | <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
> | Skype, Twitter: rowland_carson Facebook: Rowland Carson
> | pictures: http://picasaweb.google.com/rowlandcarson
>
>
|