Hi! All.
I recall that flap setting for take off on trike G-PTAG was 18Deg.
Regards
Bob Harrison.
-----Original Message-----
From: owner-europa-list-server@matronics.com
<owner-europa-list-server@matronics.com> On Behalf Of Paul M 383
Sent: 04 June 2021 02:16
Subject: Europa-List: Re: Flap limiting speed 83 kts exceeded
--> <europaul383@hotmail.com>
JonathanMilbank wrote:
> ...create an intermediate 18 degree detent notch, which happens to lie
approximately halfway along the slot...
>
> Why Neville specified 18 degrees is something I never questioned, ... if
... different Vfe speeds for varying flap settings, then ... Vfe for 18
degrees would be considerably higher than 83 knots; perhaps a lot closer to
100 knots.
>
> That was a long-winded explanation where I could simply have replied 'as
well as'.
Yes it was (:-D), but it answers my question, thanks.
Might 18 be the takeoff flap setting for a Trigear? I don't have one but
you do and I guess it's in the Owner's Manual? This might then answer your
question (on Vfe for 18) ... if you read Bud's reply and do some math(s).
HTH
P
G-PLPM
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=502236#502236
This email has been scanned by BullGuard antivirus protection.
For more info visit www.bullguard.com
|