Nigel,
I have had pretty good success in using a fly cutter. You must make some
changed though. Take the drill out and make a new center guide that has a
smooth 1/8 inch diameter end. Take the cutter off and grind it so that it will
produce a thin cut line. The cutters angle of point should be such that it
won't "dig in" as it is rotating. Pre-drill a 1/8 inch hole for your new
center guide to fit into. Use it in a variable speed drill at the slowest
speed possible. Practice on a similar piece of scrap before touching your
"baby" with it. It works on lectern too.
Troy -N120EU
|