This mount has the added advantage of using the nut
> plates in their intended orientation rather than inverted (!) per the
> manual rhetorical question: has anyone been able to put a bolt into
> one of these nutserts from the wrong end? With the normal exit end pinched to
> smaller than the bolt diameter, that is not possible with any of the
> nutserts delivered with my kit.
I used the ones supplied with the kit. Before you rivet the nut plate in place
thread a bolt in from the proper side a couple of times. This will give just
enough slack to allow you to insert the bolt from the wrong side when you come
to mount the servo.
Tony
|