Mike,
FL13 is used in the outboard flap hinge, not the aileron. The link rod
attachment to the aileron has no FL13 - see Fig 5 on page 9-3. Just use two
EUR001s and one MS21042-4.
Regards,
Jeremy
Jeremy Davey
Europa XS Monowheel 537M G-EZZA
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
DuaneFamly@aol.com
Subject: Europa-List: Aileron Link Rod
Greeting to all,
I just made up my first aileron link rod. But when I went to attach it to
the
aileron it didn't fit. The MW4 Rod End ID is .250 but the FL13 Spacer OD is
.315. So I figure it goes on the bolt itself up aginst the ER001, then the
spacer, washer, and nut. But there's not enough room on the bolt to handle
all
this. What did I do wrong? Bolt seated too deep?
Mike Duane A207
Redding, California
XS Trigear
|