Hi to All who have gone before me,
I make note of the list of metric drill bits on Pg. 1-3 of manual. After
determining that the 3.3mm bit is essential for the flush pop rivits, I've
found that McMaster-Carr carries a line of metric drill bits.
Lazy as I am, I have not searched through the entire manual to determine
whether the 4.2mm, 4.8mm, 10.2mm, and 12mm are similarly essential, or if
they are simply metric equivalents for the listed fractional-inch sizes also
listed.
Before I order all the listed metric bits, can someone enlighten me as to
whether or not they are essential...assuming of course that one has a full
set of fractional-inch bit sizes?
Metrically-challenged Fred, A194
|