Hi! Frans.
Just occurred to me .....are the bellcranks of equal leg, because if not
you may have one incorrect way round giving you unequal movements?
Regards
Bob Harrison G-PTAG
-----[/quote:04b201de89]
You mean that I might have mounted it incorrectly? I checked everything already,
this is not the case. The error would then be much higher. I suspect the problem
what I have is due to the accumulation of build- and part tolerances. If
you are lucky consequitive tolerances cancel each other out, in my case they
probably
work in the same direction. Maybe I should just swap the bell cranks?
;-)
I found that the starboard aileron drive pin is 1mm too close to the hinge.
Could
this be the cause?
Frans
Visit - www.EuropaOwners.org
|