Way back in chapter 17 of the manual, there was a paragraph thus:
Using scrap blue foam, make up spacers to fill the areas each side of the
control
tunnels, so that a flat surface results for the seat pans
Ive carved foam blocks that fit nicely in the recesses but I feel that bare blue
foam is a bit prone to damage. Im inclined to coat each block in a single layer
of BID (with flox corners and all that good stuff). Yes, it will add a bit
of weight, but I think it might prevent the need to re-make the packing blocks
after some time in service.
Has anyone else any thoughts about the advisability or otherwise of this course
of action?
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
|