How did you handle your fuel filters that go there?
Sent from my iPhone
> On Apr 1, 2017, at 12:03 PM, Rowland Carson <rowlandcarson@gmail.com> wrote:
>
>
> Way back in chapter 17 of the manual, there was a paragraph thus:
>
>
>
> Using scrap blue foam, make up spacers to fill the areas each side of the
> control
tunnels, so that a flat surface results for the seat pans
>
>
>
> Ive carved foam blocks that fit nicely in the recesses but I feel that bare
> blue
foam is a bit prone to damage. Im inclined to coat each block in a single
layer of BID (with flox corners and all that good stuff). Yes, it will add a bit
of weight, but I think it might prevent the need to re-make the packing blocks
after some time in service.
>
> Has anyone else any thoughts about the advisability or otherwise of this
> course
of action?
>
> in friendship
>
> Rowland
>
> | Rowland Carson ... that's Rowland with a 'w' ...
> | <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
> | Skype, Twitter: rowland_carson Facebook: Rowland Carson
>
>
>
>
>
|