Ditto!
Brian, G-DDBD
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
davidjoyce@doctors.org.uk
Sent: 01 April 2017 20:51
Subject: Re: Europa-List: seat base foam blocks
Rowland, My naked blue foam blocks have survived perfectly for 15 yrs!
Don't add unecessary weight!
Regards, David, GXSDJ
On 2017-04-01 20:03, Rowland Carson wrote:
<rowlandcarson@gmail.com>
Way back in chapter 17 of the manual, there was a paragraph thus:
"Using scrap blue foam, make up spacers to fill the areas each side of
the control tunnels, so that a flat surface results for the seat pans"
I've carved foam blocks that fit nicely in the recesses but I feel that
bare blue foam is a bit prone to damage. I'm inclined to coat each block
in a single layer of BID (with flox corners and all that good stuff).
Yes, it will add a bit of weight, but I think it might prevent the need
to re-make the packing blocks after some time in service.
Has anyone else any thoughts about the advisability or otherwise of this
course of action?
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
ttp://www.matronics.com/Navigator?Europa-List
ics.com
.com
.matronics.com/contribution
No virus found in this message.
Checked by AVG - www.avg.com <http://www.avg.com/email-signature>
04/01/17
|