>One consideration may be your method of supporting the canoe
Fred - thanks for your comments. I am (at present) using an old door
on castors with wedges at the ends for support - see the pictures on
my website at
<http://home.clara.net/rowil/aviation/fuselage_dolly.html>. The
fuselage floor is relatively flat where the seat-backs are, and it is
in contact with the door almost all the way across at that fuselage
station. This matches the pretty flat profile across the width of the
cockpit module underside.
>I built one of Chuck Popenoe's knock down support frames
I did consider something similar but laziness won! It would be great
if someone made a file of fuselage profile measurements for cutting
support formers.
>don't hesitate to lay the Redux on thick when the time comes to bond
>in the CM and take care as to not localize pressure with blocking
>and strapping
That all sounds good advice, thanks.
regards
Rowland
--
| Rowland Carson LAA #16532 http://home.clara.net/rowil/aviation/
| 1110 hours building Europa #435 G-ROWI e-mail <rowil@clara.net>
|