N460HJ cabin exhaust...the fuel tank outlet covers
\[image: image.png]
[image: image.png]
William Daniell
LONGPORT
+1 786 878 0246
On Fri, Aug 25, 2023 at 6:52=AFPM Pete <peterz@zutrasoft.com> wrote:
>
> Area of the bulkhead slot isnt any smaller than my existing reverse naca
> behind the doors fwiw.
>
> > On Aug 25, 2023, at 6:40 PM, Area-51 <goldsteinindustrial@gmail.com>
> wrote:
> >
> goldsteinindustrial@gmail.com>
> >
> > Peter the trim slots are shielded by a forward bulkhead feature on 181,
> so air flow to these slots is very limited.
> >
> > Implementing rear side exhaust ports near the Hstab has its own set of
> challenges and issues regarding structural integrity and fatigue of the
> Hstab root area.
> >
> > Some tricky "multi-phase" solutions are required on this subject to
> factor in prop swirl and exhaust gas paths from the engine's tail pipe;
> which means a "press Solve button and go to bed" situation.
> >
> >
> >
> >
> > Read this topic online here:
> >
> > http://forums.matronics.com/viewtopic.php?p=511352#511352
> >
> >
> >
> >
> >
> >
> >
> >
> >
>
===========
===========
===========
===========
===========
>
>
|